Engineering, 16.04.2020 22:30 rosaa7

Last casing: 7 5/8” 29.7 lb/ft ID 6.975” set and cemented at 8000 ft. The hole is vertical to this point.
FIT Pressure: 2330 psi for 7 5/8" casing string
Bit size: 6.5”
Drill pipe: 5” 19.5 lb/ft ID 4.276” X-95 Premium Class
BHA: 600 ft of 6” X 2” Drill collars 85.4 lb/ft
Derrick is strung with 12 lines
Traveling block weight: 20,000 lbs.
Top Drive Weight: 35,000 lbs
Triplex pump. 6.5” liners, 11 inch stroke. 95% efficiency
Pump Rate: 100 strokes/minute
Mud Weight: 9.8 ppg
SG of Cuttings: 2.6
Washout: 0%
The hole is at a 20 degree angle from 8000 ft MD to TD (Final Depth). It is vertical to 8000 ft MD.

Given the above listed FIT was performed to 2330 psi and the fracture pressure increases by 0.045 psi/ft/1000ft for the rest of the well. The pore pressure gradient at the shoe is 0.721 psi/ft increasing by 0.012 psi/ft/1000ft. Given a safety margin of 0.3 ppg for both pore pressure and fracture pressure. What TVD can be achieved before needing to run an additional string of casing?

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Aseries piping system conveys methyl alcohol. the system consists of 70 m of 1- nominal pipe follow by 50 m of 2-nominal pipe, both schedule 40 commercial steel. the 1-nominal pipe contains 3 90° elbows (regular) anda fully open gate valve, all threaded. the pressure drop through the system is 150 kpa. determine the volume flow rate through the system that is horizontally laid.

Answers: 1

Answer

You know the right answer?

Last casing: 7 5/8” 29.7 lb/ft ID 6.975” set and cemented at 8000 ft. The hole is vertical to this p...

Questions