Engineering, 18.04.2020 20:42 mikisims

Q3 A falling film of water at 30oC and total pressure of 1.45 bar is used to absorb a solute (A) from an insoluble gas. The mass transfer coefficient at the given velocity is estimated to be kc = 90.3 kmol/h. m2 (kmol/m3). It is known that 13.6% of the total mass transfer resistance lies in the gas-phase. At a particular section of the apparatus, the mole fraction of the solute in the bulk gas is 0.065 and the interfacial concentration of the solute in the liquid is (0.00201). The equilibrium solubility of the gas in water at the given temperature is:-
PA = 3.138 x*
Where P is the partial pressure of A in gas in mmHg and x* solubility of A in mole fraction, gas constant 0.0831bar. m3/ k. kmol. Calculate:-
1- Absorption flux of the gas at the given section of the apparatus.
2- The bulk liquid concentration at that section of the apparatus.
3- The overall liquid-phase mass transfer coefficient.
4- The individual and overall gas-phase driving forces in terms of ΔP and Δy where 1.013 bar=760 mmHg. . A

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 08:10

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

Answer

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

You know the right answer?

Q3 A falling film of water at 30oC and total pressure of 1.45 bar is used to absorb a solute (A) fro...

Questions