Engineering, 21.04.2020 19:26 Buttercream16
An insulated rigid tank is initially evacuated. A valve is opened, and atmospheric air at 95 kPa and 17 ºC enters the tank until the pressure in the tank reaches 95 kPa, at which point the valve is closed. Determine the final temperature of the air in the tank. Assume constant specific heats.
Answers: 3
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
An insulated rigid tank is initially evacuated. A valve is opened, and atmospheric air at 95 kPa and...
English, 23.11.2019 16:31
Biology, 23.11.2019 16:31
Social Studies, 23.11.2019 16:31
Mathematics, 23.11.2019 16:31
Mathematics, 23.11.2019 16:31
Social Studies, 23.11.2019 16:31
Mathematics, 23.11.2019 16:31
English, 23.11.2019 16:31
Mathematics, 23.11.2019 16:31
Computers and Technology, 23.11.2019 17:31