3. When starting an automatic transmission
vehicle, the selector lever should be in
(a)...
Engineering, 22.04.2020 00:53 Jmarie08
3. When starting an automatic transmission
vehicle, the selector lever should be in
(a) LOW-L1 or L2, (c) PARK-P or
or 1 or 2
NEUTRAL-N
(b) DRIVE-D
(d) REVERSE-R
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
You know the right answer?
Questions
Mathematics, 22.10.2019 03:00
Spanish, 22.10.2019 03:00
Mathematics, 22.10.2019 03:00
Mathematics, 22.10.2019 03:00
Mathematics, 22.10.2019 03:00
Social Studies, 22.10.2019 03:00
