subject
Engineering, 22.04.2020 02:29 jlmn5953

The company you work for signed a contract with a security firm to control access to company grounds and corporate offices. The contract amount was for $140,000 for the first year, renewable each year for up to a total of 5 years at the same cost plus a percentage increase equal to the inflation rate for the preceding year. Your boss asked you to calculate the expected cost in the final year of the contract (year 5), assuming the inflation rate is 3% for the next 3 years and 5% for the last one.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
You know the right answer?
The company you work for signed a contract with a security firm to control access to company grounds...
Questions
question
Engineering, 14.04.2021 17:30
question
Geography, 14.04.2021 17:30
question
English, 14.04.2021 17:30
question
Physics, 14.04.2021 17:30
question
Mathematics, 14.04.2021 17:30
question
Mathematics, 14.04.2021 17:30
Questions on the website: 13722361