Engineering, 22.04.2020 03:05 rubyhart522

The fuel of problem 4 was used to run a spark-ignition engine in a laboratory environment simulating the atmosphere of planet Mars. The intake air was composed of (O2 + 3CO2). Stoichiometric amounts of "air" and fuel enter the engine at 25°C, while combustion products in the exhaust manifold are at an average temperature of 1000 K. Only products of complete combustion are found in the exhaust. It is measured that the engine produces 2.0 kW of power while the heat transfer rate to the surroundings is 1.0 kW. a) Determine the mass flow rate of the fuel supplied to the engine. b) Determine the fuel conversion efficiency of the engine when operated with the proposed fuel

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

Answer

You know the right answer?

The fuel of problem 4 was used to run a spark-ignition engine in a laboratory environment simulating...

Questions