Engineering, 22.04.2020 02:55 robertsabbiegale
You are the quality control manager at a steel mill making sheet metal. The thickness of the sheet metal being pressed is measured at the rollers with a LVDT. A set of LVDT voltage readings are tabulated in the data below. The LVDT used for measurements is a RDP Electrosense ACT1000A, powered at 7 VAC. Use the information to determine the average thickness of each sheet, which are outside tolerance and the average thickness of the "good" sheets. What gauge sheet metal is being produced?
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:10
The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:10
Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa
Answers: 1
You know the right answer?
You are the quality control manager at a steel mill making sheet metal. The thickness of the sheet m...
Questions
Computers and Technology, 30.03.2020 21:07
Social Studies, 30.03.2020 21:07
Spanish, 30.03.2020 21:07
English, 30.03.2020 21:07
Mathematics, 30.03.2020 21:07
Mathematics, 30.03.2020 21:07
