Engineering, 22.04.2020 22:58 TheBurntToast
A good rule of thumb is to design the horizontal stabilizer so that its area is about 1/6 to 1/8 of the area of the wing. If the area of the wing is 101.25 cm2, which of the following would be a good horizontal stabilizer design?
Stabilizer with area = 32 cm2.
Stabilizer with area = 20 cm2.
Stabilizer with area = 14 cm2.
Stabilizer with area = 11 cm2.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
A good rule of thumb is to design the horizontal stabilizer so that its area is about 1/6 to 1/8 of...
Questions
World Languages, 30.04.2021 05:50
History, 30.04.2021 05:50
Social Studies, 30.04.2021 05:50
Mathematics, 30.04.2021 05:50
Computers and Technology, 30.04.2021 05:50
Mathematics, 30.04.2021 06:00
Mathematics, 30.04.2021 06:00
