Engineering, 23.04.2020 21:25 lakhanir2013

A board game has 20 squares in a row. You start at square 1 and end at square 20. You cannot move beyond 20. If your move goes beyond 20, you cannot move and you do nothing during the turn. You spin a wheel where the probability of each move is a follows
Move Percent

1 square toward the finish 10
2 squares towards the finish 10
3 squares towards the finish 10
4 squares towards the finish 10
5 squares towards the finish 10
6 squares towards the finish 10
Nothing 10
Move 1 squares back 10
Move 2 squares back 10
Move 3 squares back 10

Draw the markov chain?
What is the chance the game ends prior to the 11th move?
What is the chance the game ends prior to the 21th move?
What is the chance the game ends prior to the 31th move?
What is the chance the game ends prior to the 41th move?
What is the chance the game ends prior to the 100th move?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:10

Apressure vessel with an r/t 20 cannot be treated as thin walled vessel. a)-trune b)- false

Answers: 3

Answer

Engineering, 04.07.2019 19:10

The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Liquid flows at steady state at a rate of 2 lb/'s through a pump, which operates to raise the elevation of the liquid 100 ft from control volume inlet to exit. the liquid specific enthalpy at the inlet is 40.09 btu/lb and at the exit is 40.94 btub. the pump requires 3 btu/s of power to operate. if kinetic energy effects are negligible and gravitational acceleration is 32.174 tt/s, the heat transfer rate associated with this steady state process is most closely 1)-2,02 btu/s from the liquid to the surroundings 2)-3.98 btu/s from the surroundings to the liquid. 3)-4.96 btu/s from the surroundings to the liquid. 4)-1.04 btu/s from the liquid to the surroundings.

Answers: 2

Answer

You know the right answer?

A board game has 20 squares in a row. You start at square 1 and end at square 20. You cannot move be...

Questions