Engineering, 23.04.2020 23:12 Gattuso

Design1 a combined cycle power plant to generate a net power output of 550 MW. The maximum temperature of the Brayton cycle is 1150 K. Air intake condition is 100 kPa and 30°C. Condenser pressure of the Rankine cycle is 45 kPa. Boiler (heat exchanger) pressure of the Rankine cycle is 10 MPa. The isentropic efficiency of the gas turbine is 0.87 and that of the compressor is 0.85. Isentropic efficiency of the feedwater pump is 0.8, and that of the steam turbine is 0.81. Use constant specific heats for air at the inlet temperature to each component. Use EES to:

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 06.07.2019 02:30

A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush

Answers: 3

Answer

Engineering, 06.07.2019 02:30

1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction

Answers: 1

Answer

Engineering, 06.07.2019 04:10

Aheat pump that operates on the ideal vapor compression cycle with refrigerant-134a is used to heat water from 15°c to 45°c at a rate of 0.12 kg/s. the condenser and evaporator pressures are 1.4 and 0.32 mpa, respectively determine: (a) the power input to the heat pump

Answers: 1

Answer

You know the right answer?

Design1 a combined cycle power plant to generate a net power output of 550 MW. The maximum temperatu...

Questions