Engineering, 24.04.2020 00:33 diamond8189

You and your design group are competing for a multidisciplinary concept project. Your firm is the lead group in the design professional consortium formed to compete for the project. Your consortium has been selected to be the first to enter fee negotiations with the project owner. During negotiations, the amount you have to cut from your fee to be awarded the contract will require dropping one of the consortium members whose staff has special capabilities not found in the staff of the remaining consortium members. Is your consortium response in the negotiations ethical?

a. No, not if the owner is left with the impression that the consortium is still fully qualified to perform all the required tasks.

b. Yes, if your remaining consortium members hire a few new, lower cost employees to do the special work originally intended to be provided by the consortium member dropped

c. No, because an engineer may not accept a contract to coordinate a project with other professional firms providing capabilities and services not under the engineer's direct control

d. Yes, if in accepting an assignment to coordinate a project, a single person will sign and seal all the documents in the entire consortium work.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

You know the right answer?

You and your design group are competing for a multidisciplinary concept project. Your firm is the le...

Questions