Engineering, 24.04.2020 17:49 chrisholmes176

The inspection department in an automobile final assembly plant checks cars coming off the line against 85 features that are considered critical-to-quality characteristics for customer satisfaction. During a one-month period, a total of 16,578 cars were produced. For those cars, a total of 1,989 defects of various types were found, and the total number of cars that had one or more defects was 512.
Determine:
(a) The number of defects per million opportunities and corresponding sigma level.
(b) The number of defects per million and corresponding sigma level.
(c) The number of defective units per million and corresponding sigma level.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Apure substance is a)-mixture of various chemical elements or compounds b)-substance that has a fixed chemical composition throughout c)-mixture that is homogeneous (such as air) d)-all the answers

Answers: 3

Answer

Engineering, 04.07.2019 19:20

A21-tooth spur pinion mates with a 28-tooth gear. the diametral pitch is 3 teeth/in and the pressure angle is 20°, find the following values: the addendum, dedendum, circular pitch, tooth thickness, and base circle diameters.

Answers: 2

Answer

You know the right answer?

The inspection department in an automobile final assembly plant checks cars coming off the line agai...

Questions