Engineering, 24.04.2020 18:17 jacobgooding830

The 500- bed Lotta Hart Hospital has a small activated sludge plant to treat its wastewater. The average daily hospital discharge is 1500 L per day per bed, and the average soluble BOD5 after primary settling is 500 mg/L. The aeration tank has effective liquid dimensions of 10m wide by 10m long by 4.5m deep. The plant operating parameters areas follows: MLVSS =2500mg/L MLSS= 1.20 (MLVSS) Determine the following: aeration period, F/M ratio, SVI, solids concentration in return sludge. Using the following assumptions, determine the solids retention time, the cell wastage flow rate, and the return sludge flow rate for the Lotta Hart Hospital WWTP (Problem 1. ). Assume: Allowable BOD5 in effluent = 25 mg/L Suspended solids in effluent = 25 mg/L Wastage is from the return sludge line Yield coefficient = 0.60 mg VSS/mg BOD5 removed Decay rate of microorganisms = 0.060 d-1

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

Answer

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

Answer

You know the right answer?

The 500- bed Lotta Hart Hospital has a small activated sludge plant to treat its wastewater. The ave...

Questions