subject
Engineering, 24.04.2020 21:46 emmanuellugo40

An arrival rate of 720 veh/h arrive at a single lane signalized approach that is controlled by a traffic signal that operates at a cycle length of 60 seconds and a 50:50 green split. The amber and all-red interval is 5 seconds. The unopposed saturation flow rate was measured to be 1800 veh/h/lane with a start-loss 2 seconds and end gain of 3 seconds, respectively. For the approach do the following for a single cycle length:

a. Compute the maximum queue size formed upstream the traffic signal.

b. Compute the time required to dissipate the queue.

c. Compute the average vehicle delay experienced by vehicles traveling on the approach using the macroscopic procedures that were described in the class.

d. Compute the average vehicle delay experienced by vehicles traveling on the approach by tracking the arrival and departure times of each vehicle. Assume the first vehicle arrives at the midheadway after the red interval starts.

e. Repeat part (d) considering the first vehicle arrival ranges from 0 to 5 seconds. Comment on the sensitivity of delay estimates to the arrival time of the first vehicle.

f. Compute the number of vehicles that come to a complete stop during the cycle length.

g. Compute the maximum delay experienced by a vehicle.

h. What is the delay experienced by the third vehicle in queue assuming that the first vehicle arrives at the start of the red.

The Cycle length is 60 seconds. The problem should be solved fo a single cycle length.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
You know the right answer?
An arrival rate of 720 veh/h arrive at a single lane signalized approach that is controlled by a tra...
Questions
question
Mathematics, 18.07.2019 07:00
question
Social Studies, 18.07.2019 07:00
question
Mathematics, 18.07.2019 07:00
Questions on the website: 13722361