subject
Engineering, 06.05.2020 08:40 annie1799

From each of the following english sttements (1) translate into predicate logic, (2) write the nagation of that statement in predicate logic with the negation symbols pushed as far in as possible so that any neggation symbols are directly in front of a predicate, and then (3) write a natural traslation of (2) to english .

For the logic, let your domain of discourse be programs and values. You should use only the predicates Accepts(x, y) and Returns(x, y) which say that a program z accepts a value y as input or that returns y as output; the predicates Program(x) and Value(2), which say whether is a program or a value (respectively); and the predicates r=y and r y, which say whether I and y are the same object

(a) [6 points) "Hello" is the only value that the program HelloWorld returns.
(b) [6 points) There is a value that is accepted by some program but returned by all programs.
(c) [6 points) Programs that return "Hello" don't accept some value.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.
Answers: 2
question
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
question
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
question
Engineering, 04.07.2019 19:20
Acommercial grade cubical freezer, 4 m on a side, has a composite wall consisting of an exterior sheet of 5.0-mm thick plain carbon steel (kst= 60.5 w/m k), an intermediate layer of 100-mm thick polyurethane insulation (kins 0.02 w/m k), and an inner sheet of 5.0- mm thick aluminium alloy (kal polyurethane insulation and both metallic sheets are each characterized by a thermal contact resistance of r 2.5 x 104 m2 k/w. (a) what is the steady-state cooling load that must be maintained by the refrigerator under conditions for which the outer and inner surface temperatures are 25°c and -5°c, respectively? (b) for power saving purpose, which wall material should be increased/reduced in. thickness in order to reduce 50% of the cooling load found in part (a)? redesign the thickness of the proposed material. 177 w/m-k). adhesive interfaces between the q=575.93 w
Answers: 2
You know the right answer?
From each of the following english sttements (1) translate into predicate logic, (2) write the nagat...
Questions
question
Mathematics, 06.05.2020 06:05
question
Mathematics, 06.05.2020 06:05
question
Mathematics, 06.05.2020 06:05
Questions on the website: 13722363