subject
Engineering, 06.05.2020 06:35 firstone04kr

Develop a spreadsheet using the Modified Puls method to route runoff through the specified pond configuration: Storage - At a stage of 0 ft (brim full), the pond has an area of 1 acre. From a stage of 0 ft to a stage of 3 ft, the pond increases to an area of1.5 acres. From a stage of 3 to 5 ft, the pond increases to an area of 2.25 acres. The stage should not increase above 5 ft Hint: develop an equation for this stage-area relationship for use in spreadsheet Hint: After areas are calculated for each stage, they must be converted to storage iven, see attached spreadsheet The pond has an outlet structure with a 6 inch orifice with the invert set at a stage of 0 The pond has a weir set at a stage of 2 that is 6 feet long Change int5 min Deliverables a) Draw a cross section of the pond showing the changes in pond size as the stage increases. Include a cross section of the outlet structure showing the two outlets set at the correct stage b) Develop a stage / storage relationship for the pond from a stage of 0 to 5 ft. c) Develop a stage / discharge relationship for the pond from a stage of 0 to 5 ft d) Develop a graph showing the relationship between outflow and 2S*/dt + O+ e) Use the attached table as a guide to route the given inflow hydrograph through the system (note, continue the routing until outflow stops or recedes to a very lovw eve f) Graph the inflow and outflow hydrographs on top of one another *provide items b, c, d, e and f as tables or graphs as appropriate

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:10
Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges
Answers: 1
You know the right answer?
Develop a spreadsheet using the Modified Puls method to route runoff through the specified pond conf...
Questions
question
Mathematics, 07.12.2020 19:30
question
Biology, 07.12.2020 19:30
question
Mathematics, 07.12.2020 19:30
question
Computers and Technology, 07.12.2020 19:30
question
Chemistry, 07.12.2020 19:30
question
Mathematics, 07.12.2020 19:30
Questions on the website: 13722359