subject
Engineering, 05.05.2020 19:01 bbahena46

In one of her experiments, she used a binary mixture of n-pentane (density 39.1 lbm/ft^3) and p-xylene (density 53.8 lbm/ft^3). One outlet stream of her condenser was measured to have a flow rate of 37 ft^3/min and a concentration of 30/70 n-pentane/p-xylene by volume. The other outlet stream was measured to have a flow rate of 22 ft^3/min and a concentration of 50/50 n-pentane/p-xylene by volume. If the system operates at steady state and the only inlet to her condenser has a flow rate of 59 ft^3/min, what is the inlet concentration of n-pentane in % by volume?Your answer should be between 0 and 100. Round your answer to 1 decimal place for entry into eCampus. Do not enter units. Example: 12.3

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
question
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:20
How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s
Answers: 2
You know the right answer?
In one of her experiments, she used a binary mixture of n-pentane (density 39.1 lbm/ft^3) and p-xyle...
Questions
question
Biology, 28.01.2020 10:31
question
Advanced Placement (AP), 28.01.2020 10:31
question
English, 28.01.2020 10:31
question
Mathematics, 28.01.2020 10:31
Questions on the website: 13722367