Engineering, 05.05.2020 11:14 queenskyyt

I need help calculating these for my CEA class, help please!

The water line is 15 years old.
The elevation at the lowest point of the tower’s water cavity is 872.81 ft.
The elevation at point of discharge 765 ft.
The pipe’s diameter is 6 in.
The pipe’s length is 3 miles.
The pipe is cast iron.
The pipe has seven 90-degree flanged elbows and one 45-degree flanged elbow.
The pipe’s flow rate is 100 gpm.
Calculate the static head at the point of discharge.
Calculate the head loss, including the losses for pipe fittings.
Calculate the dynamic head at the point of discharge .
Is the actual pressure sufficient for residential use? Should a pressure-reducing valve be installed?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

Answer

You know the right answer?

I need help calculating these for my CEA class, help please!

The water line is 15 years...

Questions