subject
Engineering, 05.05.2020 09:15 patelandrew816

Alright guys so this really annoying moderator (all mods on ANY website are annoying so what can you expect) i was doing a challenge with my friend to see who could get the most points and then this person just took away all my points and ALL my brainless even though i hadn't earned the point fairly, the brainliest thing was just unacceptable... i had spent over 45 minutes researching someones question because the reward was brainliest and 100 points and i was really dissapointed to see that this dumb moderator took it away she even got mad on my very serious question (THAT I SPENT POINTS ON BTW) the most points i got from a single person was 15 all the other points were earned by doing challenges now because of her i lost 10$ (the deal with my friend) but then i realized she was probably just jealous because she didnt have any friends she will probably take this question down so she doesnt seem like a bad person but heres some free points to whoever sees this please spread awareness about bad moderators :)

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:20
For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor
Answers: 3
question
Engineering, 04.07.2019 19:10
The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false
Answers: 2
question
Engineering, 04.07.2019 19:20
Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?
Answers: 2
question
Engineering, 06.07.2019 03:10
How to convert a friction to decimal ?
Answers: 1
You know the right answer?
Alright guys so this really annoying moderator (all mods on ANY website are annoying so what can you...
Questions
question
Mathematics, 17.12.2020 20:30
question
History, 17.12.2020 20:30
question
Mathematics, 17.12.2020 20:30
question
Mathematics, 17.12.2020 20:30
question
Mathematics, 17.12.2020 20:30
Questions on the website: 13722361