Engineering, 05.05.2020 08:14 rosie20052019

A concentrating solar power (CSP) plant is planned for a site about 40 miles due south of Albuquerque, NM and about 10 miles east of the town of Belen, NM. The plant will operate with a steam power cycle with a low temperature of 50C, a boiler pressure of 80 bar, and a superheat maximum temperature of 350C. Use NREL’s "Solar Prospector" for solar resource evaluation. What is the approximate total solar concentrator aperture area required to achieve an 80 MW output for the power plant? (note: aperture area = solar concentrator projected area = width (aperture) x length of collector)

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Apreheater involves the use of condensing steam at 100°c on the inside of a bank of tubes to heat air that enters at 1 atm and 25°c. the air moves at 5 m/s in cross flow over the tubes. each tube is 1 m long and has an outside diameter of 10 mm. what is the minimum value of nl needed to achieve an outlet temperature of t 75 c? what is the corresponding pressure drop across the tube bank?

Answers: 3

Answer

You know the right answer?

A concentrating solar power (CSP) plant is planned for a site about 40 miles due south of Albuquerqu...

Questions