Engineering, 05.05.2020 07:16 kelyanthecrafte

Nsider the system below: (a) Derive the equation of motion of the system using both newton’s second law and the energy method. (b) Assume a value for m, r, J, k and c and plot the response of the system using Matlab or Python. Your code should superimpose the analytical solution on top of the numerically obtained one. Assume initial conditions for your system and F(t) = 0. (c) Change the parameters values in your system so that the system is undamped, overdamped, critically damped and underdamped. Plot the response of the system using Matlab or Python [both analytically and numerically in the same plot]. Assume F(t) = 0. (d) Assume a form for F(t) so that the system is unstable and characterize the type of instability. Plot the solution using Matlab or Python. (e) Assume a form for F(t) so that the system is at (1) resonance and (2) is beating. Plot the solution using Matlab or Python. (f) Solve the equation of motion of the system if

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

Answer

You know the right answer?

Nsider the system below: (a) Derive the equation of motion of the system using both newton’s second...

Questions