Engineering, 05.05.2020 07:35 richierichMBM7786

Now you have been promoted to Senior Project Manager at Build’Em High! You and your team have been awarded a big transportation project that features autonomous vehicles!

3. Matlab Programming and Psuedo Code (20 points total)

a) For the situation in which you are the driver of car driving at 55 miles per hour:

a. How do you know the speed?

b. What is the flow chart symbol for obtaining this knowledge?

b) For the situation in which you are the driver of car driving at 55 miles per hour:

a. If you are driving too fast or too slow, how do you change the speed back to 55 miles per hour?

b. What is the flow chart symbol for adjusting the speed?

c) For the situation in which you are the driver of car driving at 55 miles per hour: List the steps (and symbols) of the flow chart of the process to drive a car for 70 miles at 55 miles per hour, starting and ending at 0 miles per hour. Assume speed checks every 1 minute. Note: you may use symbols or underlined words describing symbols in your answer.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

Engineering, 04.07.2019 19:20

To save energy, the air supply to a 2000 ft office has been shut off overnight and the room temperature has dropped to 40°f. in the morning, the thermostat is reset to 70°f and warm air at 120 f begins to flov in at 200ft'/min. the air is well mixed within the room, and an equal mass flow of air at room temperature (changing with time) is withdrawn through a return duct. the air pressure is nearly 1 atm everywhere. ignoring heat transfer with the surroundings and kinetic and potential energy effects, estimate how long it takes for the room temperature to reach 70°f. plot the room temperature as a function of time.

Answers: 1

Answer

You know the right answer?

Now you have been promoted to Senior Project Manager at Build’Em High! You and your team have been a...

Questions