Engineering, 05.05.2020 05:17 nickykardashian
A 1:10 scale model of a tractor-trailer rig is tested in a wind tunnel. The model frontal area is Am = 0.1 m2 . When tested at Vm = 75 m/s in standard air, the measured drag force is FD = 350 N. Evaluate the drag coefficient for the model conditions given. Assuming that the drag coefficient is the same for model and prototype, calculate the drag force on a prototype rig at a high-way speed of 90 km/h. Determine the air speed at which a model should be tested to ensure dynamically similar results if the prototype speed is 90 km/h. Is this air speed practical? Why or why not?
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
You know the right answer?
A 1:10 scale model of a tractor-trailer rig is tested in a wind tunnel. The model frontal area is Am...
Questions
English, 06.05.2020 20:08
Biology, 06.05.2020 20:08
Arts, 06.05.2020 20:08
English, 06.05.2020 20:08
History, 06.05.2020 20:08
Mathematics, 06.05.2020 20:08
World Languages, 06.05.2020 20:08
Social Studies, 06.05.2020 20:08
