Engineering, 05.05.2020 06:56 IHeartArt2555

MOD002665 Modelling and Simulation for Operations Management
Element 011: Time Constrained course work
As a replacement for the in-class test, you are required to complete this time constrained course work. This
course work is released one week before the deadline. You should submit your completed work in Turnitin by
the deadline.
he
Course work brief:
Enten
SIGHISONSOFT
HET
HPL
HOME
PER
FEB
18
WEBSITE
PG
Flexsym is an electronic circuit manufacturing company that makes printed circuit boards (PCBs) to
multinational companies. Their manufacturing process is described on next page. You are required to write a
report of around 1000 words on how their process could be modelled and their performance improved. As
you are not required to use Witness Horizon for this work, your report is expected to be based on describing
the concepts using the given information or data rather than using simulation results. Your report is expected
to include the following tasks:
SE
BE SISTE
SEE
FEEDERBI
Ka
ER!
DER EL
F
lora
LTD
LO
FERIE
TO
USE
SLI
ASES
A brief introduction on manufacturing simulation and why simulation is considered one of the most
effective tools for decision making in manufacturing.
(10 marks)
For the given Flexsym manufacturing system, produce a pseudo representation showing the routing and
the necessary data that would aid in building the simulation model.
(20 marks)
LE

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

Answer

You know the right answer?

MOD002665 Modelling and Simulation for Operations Management
Element 011: Time Constrained cour...

Questions