Engineering, 05.05.2020 02:43 anispotts

LC3 Programming ProblemUse .BLKW to set up an array of 10 values, starting at memory location x4000, as in lab 4.Now programmatically populate the array with the numbers 0 through 9 – i. e. hard-code just the firstvalue (0), then calculate the rest one at a time, storing them in the array as you go. After you've stored them all, grab the seventh value (which would be 6) and store it in R2.As always, step through your program and examine the values as they are stored in the array, andexamine the final value stored in R2, to make sure your program works as expected.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.

Answers: 1

Answer

You know the right answer?

LC3 Programming ProblemUse .BLKW to set up an array of 10 values, starting at memory location x4000,...

Questions