subject
Engineering, 05.05.2020 06:41 miraclewhipppp

#include using namespace std; class InventoryTag { public: InventoryTag(); int getQuantityRemaining() const; void addInventory(int numItems); private: int quantityRemaining; }; InventoryTag::InventoryTag() { quantityRemaining = 0; } int InventoryTag::getQuantityRemaining( ) const { return quantityRemaining; } void InventoryTag::addInventory(int numItems) { if (numItems > 10) { quantityRemaining = quantityRemaining + numItems; } } int main() { InventoryTag redSweater; int sweaterShipment; int sweaterInventoryBefore; sweaterInventoryBefore = redSweater. getQuantityRemaining(); cin >> sweaterShipment; cout << "Beginning tests." << endl; // FIXME add unit test for addInventory /* Your solution goes here */ cout << "Tests complete." << endl; return 0; }

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
#include using namespace std; class InventoryTag { public: InventoryTag(); int getQuantityRemaining(...
Questions
question
Mathematics, 21.03.2020 05:53
question
Mathematics, 21.03.2020 05:53
question
Mathematics, 21.03.2020 05:54
question
Mathematics, 21.03.2020 05:55
Questions on the website: 13722361