Engineering, 06.05.2020 01:41 magaaalimartinez

Engineers are considering two possible vessel shapes for storing fuel. One shape is cylindrical and the other is spherical. Each vessel would be constructed out of the same material such that its hoop stresses and longitudinal stresses would be no greater than 20.0 ksi. The cylindrical pressure vessel has an inside diameter of dc = 25.0 in and a thickness of tc = 0.500 in. The spherical pressure vessel has an inside diameter of ds = 27.0 in and a thickness of ts = 0.250 in.
(a) Determine the maximum allowable pressure, p_(c, max), in the cylindrical pressure vessel. Express your answer in psi to three significant figures.
(b) Determine the maximum allowable pressure, p_(s, max), in the spherical pressure vessel. Express your answer in psi to three significant figures.
(c) Determine the required thickness of the cylindrical pressure vessel, tr, if it is subjected to the maximum allowable pressure of the spherical pressure vessel that was calculated in (b). Express your answer to three significant figures and include appropriate units.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

Answer

Engineering, 04.07.2019 18:10

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

Answer

You know the right answer?

Engineers are considering two possible vessel shapes for storing fuel. One shape is cylindrical and...

Questions