Engineering, 06.05.2020 05:43 xojade

Wastewater from a primary treatment tank is to undergo secondary treatment in an activated sludge unit. The following data and operational parameters are specified: Parameter Value Description MLVSS 3000 mgVSS/L Biomass concentration in the aeration basin μmax 1 d-1 Maximum specific BOD degradation rate kd 0.08 d-1 Cell decay rate Ks 35 mg/L Half-saturation constant Y 0.5 gVSS/gBOD Theoretical yield So 300 mg/L Initial substrate concentration Qw 10 m3/d Flow rate of waste stream Xe 10 mg/L VSS concentration at the exit stream The wastewater flow rate is 1000 m3/d, and the BOD5 of the effluent suspended solids is 80% of the allowable concentration by EPA's secondary treatment standards (30 mg/L). The MLVSS/MLSS ratio is 0.7. (a) Determine the solid retention time (units: days)

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Air inially occupying a volume of 1 m2 at 100 kpa, 27 c undergoes three internally reversible processes in series. process 1-2 compression to 500 kpa during which pv constant process 2-3 adiabatic expanslon to 100 kpa process 3-1: constant-pressure expansion to 100 kpa (a) calculate the change of entropy for each of the three processes. (b) calculate the heat and work involved in each process. (c) is this cycle a power cycle or refrigeration cycle?

Answers: 3

Answer

You know the right answer?

Wastewater from a primary treatment tank is to undergo secondary treatment in an activated sludge un...

Questions