Engineering, 31.05.2020 15:57 chickenwing32

The supplement file* that enclosed to this homework consists Time Versus Force data. The first column in the file stands for time (second) and the 2nd stands for force (Volt), respectively. This data were retrieved during an impact event. In this test, an impactor strikes to a sample. A force-ring sensor that attached to the impactor generates voltage during collision. A data acquisition card gathers the generated signals.
• Take the mass of the impactor as 30 kg and strike velocity as 2.0 m/s.
• Pick the best numerical technique, justify your choice.
• All results must be in SI units.

a) Determine a factor that will be used in the conversion from V to N. The calibration data that supplied by manufacturer as below:
• Take the mass of the impactor as 30 kg and strike velocity as 2.0 m/s.
• Pick the best numerical technique, justify your choice.
• All results must be in SI units.

a) Determine a factor that will be used in the conversion from V to N. The calibration data that supplied by manufacturer as below:• Take the mass of the impactor as 30 kg and strike velocity as 2.0 m/s.
• Pick the best numerical technique, justify your choice.
• All results must be in SI units.

a) Determine a factor that will be used in the conversion from V to N. The calibration data that supplied by manufacturer as below:
b) Compute the impulse of this event.
c) Obtain acceleration, velocity and displacement histories by using Newton’s second law of motion.
d) Compute the absorbed energy during collision.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

Answer

You know the right answer?

The supplement file* that enclosed to this homework consists Time Versus Force data. The first colum...

Questions