Engineering, 07.06.2020 00:58 yesenia1162

In water and wastewater treatment processes a filtration device may be used to remove water from the sludge formed by a precipitation reaction. The initial concentration of sludge from a softening reaction (Chapter 4) is 3 2 percent (20,000 mg/L) and the volume of sludge is 100 m . After filtra- tion the sludge solids concentration is 35 percent. Assume that the sludge does not change density during filtration, and that liquid removed from the sludge contains no sludge. Using the mass balance method, determine the volume of sludge after filtration.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

Engineering, 06.07.2019 02:30

A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.

Answers: 1

Answer

Engineering, 06.07.2019 02:30

Around steel bar, made from material with a yield stress of 750mpa, is loaded so that it has stresses co locations of maximum normal stress and maximum shear stress. use maximum shear stress and maximum distortion energy theories to calculate the safety factors for initial yielding failures.

Answers: 3

Answer

Engineering, 06.07.2019 02:30

1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction

Answers: 1

Answer

You know the right answer?

In water and wastewater treatment processes a filtration device may be used to remove water from the...

Questions