Engineering, 11.06.2020 01:57 alyea231
Share Strength
A C8 * 18.75 is to be used as tension number. The channel is bolted to a 3/8 inch gusset plate with 7/8 inch diameter, A307 bolts. A tension number is A527 Grade 50 steel and the gusset plate is A36.
A. Check all bolt spacing and edge distance requirements.
B. Calculate the design tensile strength of the tension member. Assume block shear will not govern and the gusset plate has sufficient tensile strength.
Answers: 2
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
Share Strength
A C8 * 18.75 is to be used as tension number. The channel is bolted to a 3/8 inch gu...
Computers and Technology, 02.10.2020 14:01
Social Studies, 02.10.2020 14:01
Mathematics, 02.10.2020 14:01
Mathematics, 02.10.2020 14:01
Chemistry, 02.10.2020 14:01
History, 02.10.2020 14:01
Mathematics, 02.10.2020 14:01
English, 02.10.2020 14:01
English, 02.10.2020 14:01
Geography, 02.10.2020 14:01