Engineering, 11.06.2020 20:57 madisongibson62

Write T or F next to the question number on the left side. 1. In turning, the specific energy is essentially independent of the cutting speed
2. Velocity feedback is necessary for point-to-point motion
3. The instruction for circular words in circular interpolation is always incremental
4. For enhanced productivity, it is better for the cycle time to be greater than the takt time
5. In PTP, the y axis always moves after the x axis has completed its motion.
6. In contouring, it is necessary to measure position and not velocity for feedback
7. In contouring during 2-axis NC machining, the two axes are moved at the same speed to achieve the desired contour
8. Job shop is another term for process layout.
9. Airplanes are normally produced using group technology or cellular layout.
10. In manufacturing, value-creating time is greater than takt time.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

You know the right answer?

Write T or F next to the question number on the left side. 1. In turning, the specific energy is es...

Questions