subject
Engineering, 13.06.2020 22:57 ymuttmutt3890

Write a QBasic program to sort aphetically the number of student names, each student name has first and last name like "Ahmed Yousef". The program should print the names before and after sorting. Also, the program should use "eod" as the last record in the file. The program should consider the upper and lower case for the names. 1. The first sorting should be based on the first name "Ahmed". Note that, the first names of two students may have the same first character and in this case, the sorting should be considered based on the second character of the first names of two students. 2. The second sorting should be based on the last name "Yousef". Note that, the last names of two students may have the same first character and in this case, the sorting should be considered based on the second character of the last names of two students

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
question
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
question
Engineering, 06.07.2019 02:30
An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?
Answers: 3
question
Engineering, 06.07.2019 03:10
How to convert a friction to decimal ?
Answers: 1
You know the right answer?
Write a QBasic program to sort aphetically the number of student names, each student name has first...
Questions
question
Physics, 18.02.2022 21:00
Questions on the website: 13722363