Engineering, 25.06.2020 01:01 lelseymota123

Poles are values of Laplace transform variable, s, that make denominator of transfer function zero. Zeros are values of Laplace transform variable, s, that make numerator of transfer function zero. The gain, K, is constant that multiplies entire numerator and denominator. MATLAB function, tf2zp, obtains transfer function zeros, poles, and gain given its numerator and denominator. For example, [z, p,K] = tf2zp(num, den) given a numerator, 4s2 + 165 + 12 and denominator s4 + 1253 +44s2 + 485, determine the zeros, poles, and gain of the transfer function using the tf2zp function. Poles and zeros should be ordered from largest to smallest to match the order given below. Larger number, meaning -2 > -4, NOT largest magnitude. zero(1) zero(2) pole(1) pole(2) pole(3) pole(4) gain

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

You know the right answer?

Poles are values of Laplace transform variable, s, that make denominator of transfer function zero....

Questions