subject
Engineering, 26.06.2020 15:01 wweghorst8275

Exploratory well “A” was drilled into a sand and encountered only water at a depth of 6732 ft with specific gravity 1.02 at a pressure of 3412.84 psi and temperature of 225 F. a second exploratory well, “B” was drilled updip, and found only gas at a depth of 6423 ft with a specific gravity of 0.765 at a temperature of 234 F and pressure of 3356.83 psi. Under these conditions, the Z-factor was 0.84. Using these information, estimate the depth to the G/W contact.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
question
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
question
Engineering, 04.07.2019 19:20
Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?
Answers: 2
You know the right answer?
Exploratory well “A” was drilled into a sand and encountered only water at a depth of 6732 ft with s...
Questions
question
Mathematics, 19.03.2020 01:29
Questions on the website: 13722363