The center-to-center distance from reference hole A to hole B is 3.00"+/-0.11". Hole A will be ø(4.0"+/-0.1"). If a jig is to be used to locate hole B by inserting a locator pin in hole A of ø(3.85"+/-0.05"), due to the slack between the jig locator pin and hole A: a. What are the potential limits in the location of hole B? b. Are these potential limits acceptable? c. If the potential limits are not acceptable, how would you make them acceptable? In part c, a bushing will be used to make hole B. What should be the specification for bushing location tolerance?