subject
Engineering, 29.06.2020 01:01 Delgadojacky0206

An astronaut is doing an EVA at the ISS. He is trying to screw in a bolt with a special zero-gravity wrench. After an hour of unsuccessfully using it, it breaks. The astronaut
gets so mad he winds up and throws the wrench as hard as he can toward the earth.
What will happen to the wrench after that?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
question
Engineering, 04.07.2019 18:20
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
question
Engineering, 05.07.2019 23:20
Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket
Answers: 3
question
Engineering, 06.07.2019 03:30
Abrayton cycle operates with a regenerator on the air-standard with properties evaluated at 400 k. the tem- perature of the air entering the compressor is 350k while the temperature of the air exiting the compressor is 600 k. the temperature of the air entering the turbine is 1600 k. the overall cycle produced 600 kj/kg of net work out. assuming a regenerator effectiveness of 0.8, what is the temperature of the air before heat addition (combustion)? draw this process on a t - s diagram
Answers: 3
You know the right answer?
An astronaut is doing an EVA at the ISS. He is trying to screw in a bolt with a special zero-gravit...
Questions
question
Physics, 01.04.2020 17:53
question
Mathematics, 01.04.2020 17:53
Questions on the website: 13722359