Engineering, 01.07.2020 22:01 tylerkitchen44

research the telemedicine industry and describe two companies offering services . what are the pros and cons of offering medical services this way , and is there government or industry guidance for this industry ?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 06.07.2019 04:10

Steam enters a converging nozzle at 3.0 mpa and 500°c with a negligible velocity, and it exits at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: is isentropic (a) (b) has an efficiency of 94 percent

Answers: 1

Answer

Engineering, 06.07.2019 05:10

Determine the heat loss per hour from a wall of a build- ing when the wind is blowing parallel to its surface with a speed of 2 km/hour. the wall is 5 metre long and 3 metre high. tempe rature of the wall is 25°c and air temperature is 5°c.

Answers: 2

Answer

Engineering, 06.07.2019 05:20

The inner surface of a 0.25m thick brick wall of a furnace is kept at 810ºc, when the outside surrounding air is at 22ºc. the convective heat transfer coefficient of the outer surface is 12 w/m2k and the thermal conductivity of the brick is 0.865 w/mk.neglect the convective resistance for the inner side of the furnace and assume that the problem is steady state and thermal radiation is neglected. (a)-sketch the system and calculate the rate of heat loss per unit wall area. (b)-calculate the temperature of the outer wall surface.

Answers: 2

Answer

You know the right answer?

research the telemedicine industry and describe two companies offering services . what are the pros...

Questions