Engineering, 15.07.2020 01:01 sidneydominguez2323

I SPECIFICALLY need help on the BONUS question!I only included the other questions for an understanding on the scoop of the problem. - write N-S equations for incompressible flows in cartesian coordinates in long form (in x, y,z coordinates)
- also write continuity equation and N-S equations for incompressible flows in polar coordinates in long form (inr,0.2) (since one of your friends ask you can find it easily in online resources or in books)
- Write down N-S equations in x direction for Planar Couette-Pouseille flow and derive an equation for velocity variation using boundary layer conditions mentioned in the last lecture (assuming incompressible, steady and fully developed flow)
BONUS: Assume an incompressible, steady, axissymmetric, fully developed Pouseille flow in a cylindrical pipe (infinitesimally long in z direction). The flow is in z direction, and radial and tangetial velocity is zero. Derive and simplify the N-S equation in z direction to find out the velocity in z direction. (need to use the boundary conditions to solve for integration constants)

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

You know the right answer?

I SPECIFICALLY need help on the BONUS question!I only included the other questions for an understand...

Questions