subject
Engineering, 29.07.2020 04:01 taylorbean315

Determine if each of the following statements is true or false. 1. Larger atoms are better nucleophiles due to polarizability.
A. True
B. False
2. The identity of the nucleophile affects the rate of an SN1 reaction.
A. True
B. False
3. SN2 reactions proceed via frontside attack.
A. True
B. False
4. Bimolecular reactions tend to be stereoselective.
A. True
B. False
5. SN2 reactions invert all stereocenters in a haloalkane.
A. True
B. False
6. Cl-, OH-, and H- are good all leaving groups.
A. True
B. False
7. Good bases tend to be good nucleophiles.
A. True
B. False
8. Branching adjacent to a reacting carbon slows SN2 reactions due to steric hindrance.
A. True
B. False
9. SN1 reactions are slowed by hyperconjugation of the carbocation intermediate.
A. True
B. False
10. The rate determining step for SN1 reactions is the same as the rate determining step for E1 reactions.
A. True
B. False
11. It is possible to get E1 alone but SN1 is always accompanied by E1.
A. True
B. False
12. Leaving group ability depends only on pKa of the conjugate acid.
A. True
B. False
13. Good nuclephiles are also good leaving groups.
A. True
B. False
14. Protic solvents solvate large ions better than small ions because of increased surface area.
A. True
B. False
15. Steric hindrance is a major factor in determining between SN2 and E2 mechanisms.
A. True
B. False
16. Backside attack always converts R to S and vice versa.
A. True
B. False
17. Nucleophile ability is solely dependent on the pka of the conjugate acid.
A. True
B. False
18. A high concentration of good nucleophile will increase the ratio of SN1 product to E1 product.
A. True
B. False

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
You know the right answer?
Determine if each of the following statements is true or false. 1. Larger atoms are better nucleoph...
Questions
question
Mathematics, 01.07.2020 15:01
question
Mathematics, 01.07.2020 15:01
question
Mathematics, 01.07.2020 15:01
Questions on the website: 13722367