Engineering, 05.08.2020 17:01 jahmya123
A data bus can be visualized as a multilane highway
A. and each component is located at an intersection where it will turn or go straight
B. with each component having an individual address
C. and each component located in a curve where the data will slow down
D. with each component acting as a traffic light, stop-go
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 05.07.2019 19:10
Tech a says never use a water hose to clean up dust after a repair. tech b says never use a floor scrubber to clean up dust after repairs. who is correct?
Answers: 1
Engineering, 06.07.2019 03:10
Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k,p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air
Answers: 1
You know the right answer?
A data bus can be visualized as a multilane highway
A. and each component is located at an intersec...
Questions
English, 10.05.2021 19:00
Mathematics, 10.05.2021 19:00
Mathematics, 10.05.2021 19:00
