Engineering, 12.08.2020 04:01 cajunldy2001
A long cylindrical conductor whose axis is coincident with the z axis has a radius a, and carries a current characterized by a current density = zo Jo/r, where Jo is a constant and r is the radial distance from the cylindrical axis. Obtain an expression for the magnetic field H
a. 0 ≤ r ≤ a
b. r > a.
Answers: 3
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
A long cylindrical conductor whose axis is coincident with the z axis has a radius a, and carries a...
Mathematics, 31.03.2021 17:10
Biology, 31.03.2021 17:10
History, 31.03.2021 17:10
Computers and Technology, 31.03.2021 17:10
Mathematics, 31.03.2021 17:10
Mathematics, 31.03.2021 17:10
Arts, 31.03.2021 17:10
History, 31.03.2021 17:10
Business, 31.03.2021 17:10
Health, 31.03.2021 17:10