Engineering, 12.08.2020 08:01 Emiann222

Following is the phase diagram of a hypothetical alloy, which is made by two elements B and C. The composition of the alloy is XX%C. The XX is equal to last two digits of your roll number. For example, if your roll number is MEEN19111015 then XX=15. Suppose this material is heated to 1000 oC and then cooled to 25 oC. (a)Write down the range of temperature in which two phases exist in the alloy with XX%C composition. (b) if the concentration of element C is increased, will the transformation temperature from Alpha to Beta increase or decrease

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

You know the right answer?

Following is the phase diagram of a hypothetical alloy, which is made by two elements B and C. The c...

Questions