Engineering, 13.08.2020 05:01 gg808

A heat pump system which uses R-134a operates on the ideal vapor compression heat pump cycle with a given compressor efficiency.--Given Values--Evaporator Temperature: T1 (C) = 0Condenser Temperature: T3 (C) = 37Heating Capacity: Qh (kW) = 5.8Compressor Efficiency: nc (%) = 84a) Determine the specific enthalpy (kJ/kg) at the compressor inlet. Your Answer =b) Determine the specific entropy (kJ/kg-K) at the compressor inlet. Your Answer =c) Determine the specific enthalpy (kJ/kg) at the compressor exit. Your Answer =d) Determine the specific enthalpy (kJ/kg) at the condenser exit. Your Answer =e) Determine the specific enthalpy (kJ/kg) at the evaporator inlet. Your Answer =f) Determine the coefficient of performance for the system. Your Answer =g) Determine the mass flow rate (kg/s) of refrigerant through the system. Your Answer =h) Determine the power input (kW)to the compressor. Your Answer =

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

You know the right answer?

A heat pump system which uses R-134a operates on the ideal vapor compression heat pump cycle with a...

Questions