Engineering, 19.08.2020 01:01 deon4257
A three-phase, 60-Hz, completely transposed 345-kV, 200-km line has two 795,000-cmil (403-mm2) 26/2 ACSR conductors per bundle and the following positive-sequence line constants: z 0.032 + 10.35 /km y j4.2 x 10-6 S/km Full load at the receiving end of the line is 700 MW at 0.99 p. f. leading and at 95% of rated voltage. Assuming a medium-length line, determine the following:
a. ABCD parameters of the nominal π circuit
b. Sending-end voltage Vs, current Is, and real power Ps
c. Percent voltage regulation
d. Transmission-line efficiency at full load
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:10
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
You know the right answer?
A three-phase, 60-Hz, completely transposed 345-kV, 200-km line has two 795,000-cmil (403-mm2) 26/2...
Questions
English, 29.01.2020 05:50
Mathematics, 29.01.2020 05:50
Computers and Technology, 29.01.2020 05:50
