Engineering, 29.08.2020 21:01 mariah10455
Determining that a proposed solution does not meet client requirements is an example of which step of the engineering
design process?
~build a model
~choose the best idea
~identify the problem
~test and redesign the prototype
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:20
What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.
Answers: 3
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
Determining that a proposed solution does not meet client requirements is an example of which step o...
Computers and Technology, 20.03.2020 10:07
Arts, 20.03.2020 10:07
Mathematics, 20.03.2020 10:07
Health, 20.03.2020 10:07
Mathematics, 20.03.2020 10:07
Mathematics, 20.03.2020 10:07
Mathematics, 20.03.2020 10:07
Biology, 20.03.2020 10:07
Mathematics, 20.03.2020 10:07
Mathematics, 20.03.2020 10:07