Engineering, 31.08.2020 02:01 maxg7988

1)A wheel is used to turn a valve stem on a water valve. If the wheel radius is 1 foot and the stem, (axle), radius is .5 inches, what is the mechanical advantage of the wheel and axle? 2)How much resistance force can ideally be overcome when an effort of 80 lbs is applied to the wheel of the water valve in problem 1? 3)What is the linear distance traveled when a 2.5' diameter wheel makes one revolution? 4)A compressor motor has a 1.00 inch output shaft (axle) that drives a 4.00inch pulley (wheel). If the motor output shaft supplies 24 lbs of force, ideally how much force does the pulley apply to the drive belt wrapped around it? 5) If the belt pulley's force is measured to be 4 lbs, what is the AMA wheel and axle here?6) What is the efficiency of the compressor motor – belt pulley wheel and axle?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.

Answers: 1

Answer

Engineering, 06.07.2019 02:30

Define thermoplastic polymers and thermosetting polymers in terms of their structures, and (ii) describe briefly a process suitable for the production of products from each type of polymer.

Answers: 3

Answer

You know the right answer?

1)A wheel is used to turn a valve stem on a water valve. If the wheel radius is 1 foot and the stem,...

Questions