Engineering, 01.09.2020 22:01 sadmomsclub

Verify concepts of phase equilibrium and phase transitions using the steam tables. a. Establish by direct calculation this equality between molar Gibbs free energies for steam at 2.5 MPa and 224oC : Gl = Gv
b. Calculate Gv at 2.5 MPa for temperatures between 225 and 400oC and extrapolate this curve below 224 oC.
c. Find Gl at 160, 170, 180, 190, 200, and 210 oC. Plot in the same graph used for part b and extrapolate above 224 oC. Hint: for a liquid, H and S can be taken as independent of P.
d. Plot the molar volume V vs. T at P =2.5 MPa over the T range between 150 and 400 oC, and show that V is discontinuous.
e. Plot Cp vs. T at P =2.5 MPa over the T range between 150 and 400 oC, and show that Cp is discontinuous.
f. Using the data in the steam tables, show that the Gibbs energies per unit mass of steam and liquid water in equilibrium at 300 oC are equal.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

Engineering, 06.07.2019 03:10

Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k,p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air

Answers: 1

Answer

You know the right answer?

Verify concepts of phase equilibrium and phase transitions using the steam tables. a. Establish by...

Questions