Engineering, 20.09.2020 01:01 yungdaggerdic4543
What is the ratio between driver gear A with 60 teeth and driven gear B with 180 teeth?
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
You know the right answer?
What is the ratio between driver gear A with 60 teeth and driven gear B with 180 teeth?...
Questions
Geography, 01.10.2019 18:50
History, 01.10.2019 18:50
Mathematics, 01.10.2019 18:50
Mathematics, 01.10.2019 18:50
English, 01.10.2019 18:50
History, 01.10.2019 18:50
Mathematics, 01.10.2019 18:50
English, 01.10.2019 18:50
Advanced Placement (AP), 01.10.2019 18:50
History, 01.10.2019 19:00
