Engineering, 20.09.2020 09:01 igotdiss2178

A steel spur gear and mating pinion similar to those you have seen in class have 67 and 24 teeth respectively. The pitch, P, is 12 and the pressure angle is 20°. The face width is 7/8 inch. The gears are to be used in conveyer drive. The gears operate continuously with a pinion speed of 1760 rpm. They must be 99% reliable over a period of 2 years while continuously transmitting 6 hp. In this application we know or assume: • The gears are machined.
• The velocity factor can be determined from Curve D in Figure 15.24 in J&M.
• The power source (electric motor) is uniform.
• The load is uniform.
• The gear mountings are not very rigid or accurate but contact across the full face of the gears will be obtained.
• The gear accuracy is not sufficient to assume that gear loads are shared among teeth.
• The gears operate at room temperature
a) What core hardness of the pinion is required in light of pinion tooth bending fatigue requirements?
b) What core hardness of the gear is required in light of gear tooth bending fatigue requirements?
c) What surface hardness of the pinion is required in light of pinion tooth surface fatigue requirements?
d) What surface hardness of the gear is required in light of gear tooth surface fatigue requirements?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

Answer

You know the right answer?

A steel spur gear and mating pinion similar to those you have seen in class have 67 and 24 teeth res...

Questions